Alpine CDA-7998 owner manual Equalizer Presets, Adjusting and Storing the Equalizer Curve, 7-EN

Press the EQ button and select the EQ mode.

5 Turn the Rotary encoder to adjust the level.

6 Press the SOURCE button to select your desired band width (Q).

Adjustable band width: 1, 2, 3.

To store the adjusted contents

1) Press and hold any one of the Preset buttons (1 through 6) for at least 2 seconds into which you wish to store the adjusted curve.

7 For setting another channel, repeat the steps 3 to 6.

8 After setting, press the EQ button to return to the normal mode.

NOTES

• The frequencies of adjacent bands cannot be adjusted within 4 steps.

• EQ mode is automatically canceled if no buttons are pressed within 15 seconds.

• This function is inoperable when DEFEAT is ON (refer to page 6).

Recalling the Stored Equalizer Curve

Press the g DN button or the f UP button to select your desired frequency.

Adjustable frequency bands: 20Hz to 20KHz(in 1/3 octave steps)

frequency band.

→ BAND1 → BAND2 →

4

Press the BAND

3

4 Turn the Rotary encoder to adjust the minutes while the time indication is blinking. The time is automatically set 5 seconds after the minute adjustment. The time can be manually set by pressing the MODE button.

NOTE

To synchronize the clock to a time signal, press the MODE button for at least 3 seconds after setting the “hour.” Minutes will be indicated as 00. If you press the MODE button for more than 3 seconds when the display shows over “30,” hours will advance.

Equalizer Presets

button to select your desired

BAND3 → BAND4 → BAND5

3 typical equalizer settings are preset at the factory for a variety of musical source material.

1 Press the EQ button and select the EQ mode.

2 Press either the g DN button or the f UP button.

•With each press of the button, the equalizer mode will Display the selected equalizer characteristic.

→FLAT(OFF) ↔ POPS ↔ ROCK ↔ NEWS ←

FLAT : Flat frequency

POPS : Emphasize midrange

ROCK : Emphasize lows and highs

NEWS : Boost midrange and suppress highs and lows

Selecting directly

Select the desired button (1 through 4).

[1]: FLAT(OFF)	[3]: ROCK
[2]: POPS	[4]: NEWS

3 When the setting is complete, press the EQ button to select OFF, and return to normal mode.

NOTES

•This function is inoperable when DEFEAT is ON (refer to page 6).

•EQ mode is automatically canceled if no buttons are pressed within 15 seconds.

Adjusting and Storing the Equalizer Curve

You can modify the Equalizer settings to create a response curve more appealing to your personal taste.

1 Press the EQ button and select the EQ mode.

2 Press and hold the EQ button for at least 3 seconds.

1

2 Press and hold the EQ button for at least 3 seconds.

3 Press one of 1-6buttons to activate your desired curve.

4 Press the EQ button to return to the normal mode.

NOTES

•EQ mode is automatically canceled if no buttons are pressed within 15 seconds.

•This function is inoperable when DEFFEAT is ON(refer to page 6).

7-EN