Setting Time
1Press and hold AUDIO/SETUP
2Turn the Rotary encoder to select GENERAL, and then press ENTER.
AUDIO GENERAL DISPLAY TUNER IPOD BLUETOOTH*
* CDE-W235BT only.
3Turn the Rotary encoder to select the CLOCK ADJ mode, and then press ENTER.
The time indication will blink.
4Turn the Rotary encoder to adjust the hours while the time indication is blinking.
5When the hour has been adjusted, press ENTER.
6Turn the Rotary encoder to adjust the minutes while the time indication is blinking.
7Press and hold AUDIO/SETUP
Notes
•To synchronize the clock to another clock/watch or radio time announcement, press and hold ENTER for at least 2 seconds after setting the “hour”. Minutes will reset to “00”. If the display shows over “30” minutes when you do this, the time will advance one hour.
•Pressing will return to the previous mode.
•Pressing and holding for at least 2 seconds will return to normal mode.
•If no operation is performed for 60 seconds, the unit will return to normal mode automatically.
•Even when AUTO CLOCK is set to ON (refer to “Setting the Time to automatically Adjust” on page 13), the time can be adjusted manually. At the same time, if there is an adjustment request from RDS, the time will be adjusted automatically by RDS data.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control. For details, consult your Alpine dealer. Point the optional remote control transmitter at the
Remote control sensor
Radio
Preset buttons | Preset buttons |
(1 through 3) | (4 through 6) |
| BAND | |
| |
|
TUNE/A.ME | /ENTER | |
SOURCE/ |
| Rotary encoder |
Listening to Radio
1Press SOURCEto select TUNER mode.
2Press BAND repeatedly until the desired radio band is displayed.
F1 (FM1) F2 (FM2) F3 (FM3) MW LW F1 (FM1)
3Press TUNEA.ME to select the tuning mode.
DX SEEK (Distance mode) SEEK (Local mode) off (Manual mode) DX SEEK
Note
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in (Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4Press or to tune in the desired station. Holding down or will change the frequency continuously.
