iPod

iPod does not play and no sound is output.

The iPod has not been recognised.

Reset this unit and the iPod. Refer to “Initial System Start-Up” on page 9. To reset the iPod, refer to the Owner’s Manual of the iPod.

Indication for CD Player

No CD is inserted.

Insert a CD.

Although a disc is inserted, “NO DISC” is displayed and the unit does not start to play or eject the disc.

Remove the disc by following these steps: Press the button again for at least 2 seconds.

If the disc still does not eject, consult your Alpine dealer.

Indication for USB Memory

A USB device that is not supported by the unit is connected.

– Connect a USB device that is supported by the unit.

NO DEVICE

A USB Memory is not connected.

Make sure the USB Memory device is correctly connected and the cable is not excessively bent.

No song (file) is stored in the USB Memory.

Connect the USB Memory device after storing songs (files).

• Mechanism error.

1Press the button and eject the CD.

If not ejecting, consult your Alpine dealer.

2When the error indication remains after ejecting, press the button again.

If the error indication still does not turn off after pressing the  button for a few times, consult your Alpine dealer.

When “ERROR” is displayed:

If the disc cannot be ejected by pressing , press the RESET button (Refer to “Initial System Start-Up” on page 9) and press again. If the disc still cannot be ejected, consult your Alpine dealer.

(CDE-W235BT only)

A copy-protected WMA file was played back.

You can only play back non-copy-protected files.

A sampling rate/bit rate not supported by the unit is used.

Use a sampling rate/bit rate that is supported by the unit.

(CDE-W235BT only)

A copy-protected WMA file was played back.

You can only play back non-copy-protected files.

A sampling rate/bit rate not supported by the unit is used.

Use a sampling rate/bit rate that is supported by the unit.

NO SUPPORT

Text information that is not recognizable by the unit has been input.

Use a USB Memory device with input text information that is supported by the unit.

Communication error

Turn the ignition key off, and then set to ON again.

Check the display by reconnecting between the USB Memory and this unit.

Power surge error

Excessive voltage/current is supplied to the USB Memory.

Try another USB Memory, if available.

37-EN

Page 37
Image 37
Alpine CDE-W233R, CDE-W235BT owner manual IPod, Indication for CD Player, Indication for USB Memory, 37-EN