Alpine CDE-W233R Rear/Loudness/Defeat, Audio Setup, Left and Right/Fader Between Front, 17-EN

Sound Setting

AUDIO/SETUP

/ENTER

Rotary encoder

*The illustration is for CDE-W235BT.

	AUDIO
/ENTER	SETUP

Rotary encoder

*The illustration is for CDE-W233R.

Adjusting Subwoofer Level/Bass Level/

Middle Level/Treble Level/Balance (Between

Left and Right)/Fader (Between Front and

Rear)/Loudness/Defeat

1Press AUDIO/SETUP (CDE-W235BT only) or press AUDIO (CDE-W233R only) repeatedly to choose the desired mode. Each press changes the mode as follows:

SUBWOOFER*1 BASS LEVEL*2 MID LEVEL*2 TRE LEVEL*2  BALANCE FADER LOUDNESS*2/*3 DEFEAT VOLUME 

SUBWOOFER

*1 When the subwoofer mode is set to OFF, its level cannot be

adjusted.

*2 Adjustable only when DEFEAT is OFF.

*3 For details about loudness, refer to “Turning Loudness On/Off” on page 18.

Subwoofer	+0 ~ +15
Bass level	-7 ~ +7
Middle level	-7 ~ +7
Treble level	-7 ~ +7
Balance	L15 ~ R15
Fader	R15 ~ F15
Loudness	ON/OFF
Defeat	ON/OFF
Volume	0 ~ 35

Note

•If no operation is performed for 5 seconds, the unit automatically returns to normal mode.

2Turn the Rotary encoder until the desired sound is obtained in each mode.

By setting DEFEAT ON, previously adjusted settings of BASS, MID, TRE LEVEL and LOUDNESS will return to the factory defaults.

Audio Setup

You can flexibly customize the unit to suit your own preference and usage. From the AUDIO SETUP menu, Audio Setting can be modified.

Use steps 1 to 5 to select one of the setting modes to modify. See the applicable section below for details about the selected setting item.

1Press and hold AUDIO/SETUP (CDE-W235BT only) for at least 2 seconds or press SETUP (CDE-W233R only) to activate the SETUP mode.

2Turn the Rotary encoder to select AUDIO, and then press

ENTER.

AUDIO GENERAL DISPLAY TUNER IPOD  BLUETOOTH*1

*1 CDE-W235BT only.

3Turn the Rotary encoder to select the desired sound setting menu, and then press ENTER.

FACTORY EQ*2/*3 LOUDNESS*2 3BAND EQ*2/*4 VOL LV ADJ HPF*2 SUBWOOFER SUBW LPF*2/*5 SUBW PHASE*5 

SUBW SYS*5 POWER IC

(e.g. Select SUBWOOFER)

*2 Adjustment cannot be performed when DEFEAT is set to ON. *3 The FACTORY EQ’s setting value and 3BAND EQ’s setting

value are linkage.

*4 The FACTORY EQ’s setting value and 3BAND EQ’s setting value are linkage. In step 3, three sound adjustment items (Bass, Mid and Treble) can be selected in 3BAND EQ mode, turn the Rotary encoder to select the desired item, and then press ENTER to continue to step 4.

*5 These functions are inoperable when Subwoofer is set to OFF.

4Turn the Rotary encoder to change the setting, and then press ENTER.

(e.g. Select SUBW ON or SUBW OFF)

17-EN