Installation

Installation Location

Before deciding on the mounting location, check that opening and closing the display will not hamper the gear shift in any position.

Install at an angle of within 35 degrees from the horizontal.

Caution for installation

Be sure to remove the mounting sleeve squarely from the product.

1

Mounting Sleeve

 

(Included)

Dashboard

3

Lock Pin

Slide the DVA-5210 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Detachable Front Panel.

Removal

1Use a small screwdriver (or similar tool) to push the locking pins to the “up” position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

2Pull the unit out, keeping it unlocked as you do so.

DVA-5210

Slide the mounting sleeve into the dashboard.

• Remove the wrapping from the unit.

2

Screw

Hex Nut (M5)

∗2

Bolt Stud

Metal

 

Mounting

 

Strap

∗1

DVA-5210

Ground Lead

Chassis

<JAPANESE CAR>

Head unit (Ai-NET)

Ground Lead

*3

Mounting Bracket

Face Plate

Screws (M5 8) (Included)

Screws (M5 8) (Included with the head unit)

DVA-5210

Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (∗1) already attached to the vehicle's chassis.

For the screw marked ∗2, use an appropriate screw for the chosen mounting location.

Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the DVA-5210. Connect all other leads of the DVA-5210 according to details described in the CONNECTlONS section.

Secure the ground lead of the unit to a clean metal spot using a screw (*3) already attached to the vehicle's chassis.

31-EN

Page 32
Image 32
Alpine DVA-5210 owner manual 31-EN, Installation Location, Slide the mounting sleeve into the dashboard