Alpine DVA-5210 Turning Power On and Off, When connecting to the head unit Using Ai-NET

3 Closing the cover

Slide the cover as illustrated until a click is heard.

Warning

DO NOT OPERATE ANY FUNCTION THAT TAKES YOUR ATTENTION AWAY FROM SAFELY DRIVING YOUR VEHICLE.

Any function that requires your prolonged attention should only be performed after coming to a complete stop. Always stop the vehicle in a safe location before performing these functions. Failure to do so may result in an accident.

Turning Power On and Off

Play Position Memory Function

If you turn power off or switch the ignition key to OFF during playback or change the source, playback will continue from the point where playback stopped when the power is turned ON again. The play position memory is canceled when the disc is removed.

When connecting to the head unit

using Ai-NET

Caution

•To customers using the ALPINE head unit.

Before using this unit connected to an Ai-NET compatible AV head unit or Ai-NET compatible head unit, make the appropriate settings in “Setting the System Switch” (page 32) and “Setting the Ai-NET” (page 21).

•With this unit connected to an Ai-NET compatible AV head unit or Ai-NET compatible head unit, there may be some delay during power-up from the remote control. This is caused by the systems communications being carried out by the various components and is not a defect.

•When connected with an Ai-NET compatible AV head unit or Ai-NET compatible head unit, the power cannot be turned off from the remote control. Turn off the DVA-5210 power by switching the head unit’s source. For details, refer to “Operating from the head unit” (page 22).

1Set the head unit’s source to DVD. The power turns on.

•You cannot set the source to DVD on some head units. In this case, press PWR on the remote control to turn the power on.

2 To turn the power off, change the head unit’s source.

When connecting to the head unit

without using Ai-NET

Caution

To customers connecting the head unit without Ai-NET. When using this unit without an Ai-NET connection, read “Setting the System Switch” on page 32 and set “system switching” to “2” (STANDALONE).

1 Press PWR of the remote control.

The power turns on.

2 To turn the power off, press PWR again.

8-EN