Initial System Start-Up
Be sure to press the RESET button when using the unit for the first time, after installing the CD changer, after changing the car battery, etc.
1 Turn off the unit power.
2 Open the door.
Refer to “Loading and Unloading Discs” on this page.
3 Press RESET with a
RESET
3 Close the door.
Be sure to close the door to prevent dust from entering the unit.
OPEN
•If the ignition key is on ACC or ON, a disc can be inserted even when the power is OFF.
•For
•Never insert map discs for navigation purposes as they could damage the equipment.
•If wrong disc,
“DISC ERROR” is displayed. Open the door and remove the disc.
Switching between NTSC and PAL
Set the output configuration to NTSC or PAL, depending on the disc.
Press and hold the PWR button for at least 2 seconds.
•PAL is the standard and there is no need to change the setting. The system is set to PAL at time of shipment from the factory.
Loading and Unloading Discs
Turn on the power before loading and unloading discs. (Refer to “Turning the power on and off” on page 8.)
Loading discs
1 Slide the door down to open.
OPEN
2 Insert the disc with the label side facing upwards.
Once the disc is partially inserted, it is drawn in automatically. Playback starts.
Unloading discs
1 Slide the door down to open.
2 Press c.
Be sure to remove the disc.
OPEN | c |
•If the disc is not removed within a few moments, it will be reloaded automatically.
3 Close the door.
Be sure to close the door to prevent dust from entering the unit.
•Never close the door while the disc is being unloaded. Doing so could scratch the disc or damage the player.
•If the ignition key is set to ACC or ON, a disc can be removed even when the power is OFF. After removing the disc, the power turns OFF again automatically.
•During ACC OFF or while the disc is being loaded (“LOADING”
is displayed), the disc will not be ejected even if you press c.
