Alpine IVA-D300 Getting Started, Using Face Cover, Location of Controls, Initial System Start-Up

Getting Started

About the expression of buttons in this Owner's Manual

•The buttons on this unit are expressed in bold (e.g. SOURCE/ POWER). The touch buttons on the display are expressed in bold with [ ] (e.g. [SRC]).

•This Owner’s Manual explains mainly the function of touch buttons, when a touch button and a unit button have the same function.

5
3
1	2	4

8

!

67 9 " #

Using Face Cover

An anti-theft face cover is provided with the IVA-D300.

Put the face cover onto the IVA-D300 when you leave the vehicle.

Be sure to remove the anti-theft face cover when you drive.

Location of Controls

1Rotary encoder

Adjust the volume by turning to the left or right.

If pressed, the audio adjusting screen is displayed.

2Access Indicator

Blinks when an operation is performed (except when the volume is adjusted).

3Remote Sensor

Point the optional remote control transmitter toward the remote sensor within a range of 2 m.

4SOURCE/POWER button

Turns the power on. Press and hold for at least 2 seconds to turn the power off.

Recalls the source selection screen.

5BAND/TEL. button

Radio mode: Changes the band.

Visual source (except navigation screen): Changes the display mode.

Press and hold for at least 2 seconds to change to the TEL. mode, and to be able to place or cut a call. (When MobileHub (CXA-B200NK) is connected.)

6V.SEL/OFF button

The visual selecting screen is displayed.

Press and hold for at least 2 seconds to cancel the Simultaneous function.

7V.SEL Indicator

Lights when the simultaneous function is activated. (See “Switching the Visual Source Only (Simultaneous Function)” on page 25.

8Reset Switch

Be sure to press the Reset switch when using the unit for the first time, after changing the car battery, or when an operation cannot be performed.

9MUTE button

Turns the MUTE mode ON or OFF.

!DISC-IN Indicator

This indicator is lit when a disc is inserted.

"c button Ejects a disc.

#OPEN/CLOSE/FLAT button

Initial System Start-Up

Immediately after installing or applying power to the unit, it should be initialized. Press the RESET switch with a ballpoint pen or any other pointed object.

•If the monitor was open before resetting, it will close automatically after a reset is performed. None of the buttons will function while it is closing.

Raises the monitor.

Press and hold for at least 2 seconds to lower the monitor.

Press to move the open monitor to the flat position.9

-EN