Alpine IVA-D300 owner manual Visual Eqtm, Subwoofer On and Off, Visual EQ Setting Operation, 40-EN

Storing the Adjusted Contents

Following operation is performed after Step 3 above.

4Touch [MEMORY].

5Within 5 seconds, touch any one of preset buttons [P.SET 1] through [P.SET 6] on the BASS ENGINE screen. The adjusted contents will be stored on the preset number you touch.

•The stored contents on the P.SET number remain undeleted despite a reset operation or disconnection of the battery power cord.

•Adjusted/set contents of each setting item in Bass Engine can be stored in the preset buttons (1 through 6).

Recalling the Stored Adjusting Contents

Following operation is performed after Step 3 above.

4Touch any one of [P.SET 1] to [P.SET 6] on the BASS ENGINE screen.

The stored adjusting contents will be recalled.

Subwoofer On and Off

Setting item: SUBWOOFER

Setting contents: OFF / 0° / 180°

OFF: Subwoofer output is off.

0°: Subwoofer output is on, and the phase is 0°.

180°: Subwoofer output is on, and the phase is 180°.

•Adjusted/set contents of each setting item in Bass Engine can be stored in the preset buttons (1 through 6).

VISUAL EQTM

Visual EQ Setting Operation

The following steps 1 to 6 are common operations to each “Setting item” of VISUAL EQ setting. Refer to each section for details

1 Touch [SYS.] on the main source screen.

The SYSTEM selection screen is displayed.

2 Touch [i-Personalize].

The i-Personalize setup screen appears.

3 Touch [] of VISUAL EQ.

VISUAL EQ screen appears.

4 Select a desired setting item by touching [] or

[].

Setting items:

VISUAL EQ* ↔ BRIGHT ↔ COLOR* ↔ TINT* ↔ CONTRAST

↔SHARP* ↔ USER MEMORY*

*The setting is available in the visual source mode. (except navigation screen)

5 Change the setting on the selected item by touching its [;] or [:].

6 Touch [RETURN] to return to the previous screen.

Touch [MAIN CONT.] to return to the main source screen that was displayed before the setup operation was started.

Selecting the VISUAL EQ Mode (Maker’s setting)

You can select a mode suitable for the subject image.

Setting item: VISUAL EQ

Setting contents: OFF (FLAT) / NIGHT M. / SOFT / SHARP / CONTRAST / P-1 / P-2

OFF (FLAT): Initial Setting

NIGHT M.: Suitable for movies in which dark scenes frequently appear.

SOFT: Suitable for CGs and animated films.

SHARP: Suitable for old movies where images are not clearly shown.

CONTRAST: Suitable for recent movies.

P-1: Recalls the VISUAL EQ mode being stored on preset No.P-1 from “Storing VISUAL EQ” (page 41).

P-2: Recalls the VISUAL EQ mode being saved on preset No.P-2 from “Storing VISUAL EQ” (page 41).

•To return to the initial setting after selecting any one of the setting contents (NIGHT M. to CONTRAST) and adjusting a desired brightness, picture tint, etc., set this function to OFF.

•If your desired brightness, picture tint, etc., are adjusted after selecting any one of the setting contents (NIGHT M. to CONTRAST), “CUSTOM” is displayed.

Adjusting Brightness

Setting item: BRIGHT

Setting content: -15 ~ +15

You can adjust the brightness between MIN (–15) and MAX (+15). When it reaches the minimum or maximum point, the display shows "MIN" or "MAX" respectively.

40-EN