Alpine IVA-D300 Operating Auxiliary Devices Optional, Switching the Navigation Screen Optional

Navigation System (Optional)

Switching the Navigation Screen (Optional)

If an optional Alpine Navigation System is connected to the IVA- D300, the Navigation screen can be displayed on this unit.

1 Touch [SRC] on the main source screen.

The source screen appears on the display.

2 Touch [NAV].

The Navigation screen is displayed.

The operation is possible with the supplied navigation remote control.

For navigation operation, refer to the Owner's Manual of the navigator.

•When V. SEL is pressed while the Navigation selection mode is being selected in “Setting Visual Mode” (page 33), the navigation mode will be directly activated.

•If the Navigation mode menu is not displayed on the main menu screen, set NAV. IN to on by following "Setting the navigation Mode" (page 32).

•When the Navigation System is on, the audio and visual navigation cuts in.

Auxiliary Device (Optional)

Operating Auxiliary Devices (Optional)

To operate your devices connected to the AUX terminals on the rear panel of IVA-D300, follow the procedure described below.

WARNING

It is dangerous (and illegal in many states) for the driver to watch the TV/Video while driving the vehicle. The driver may be distracted from looking ahead and an accident could occur.

Install the IVA-D300 correctly so that the driver cannot watch TV/Video unless the vehicle is stopped and the emergency brake is applied.

If the IVA-D300 is not installed correctly, the driver will be able to watch the TV/Video while driving the vehicle and may be distracted from looking ahead and cause an accident. The driver or other people could be severely injured.

To activate your auxiliary devices:

To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below.

1.Bring your vehicle to a complete stop at a safe location. Engage the parking brake.

2.Keep pushing the foot brake and release the parking brake once then engage it again.

3.When the parking brake is engaged for the second time, release the foot brake.

•For automatic transmission vehicles, place the transmission lever in the Park position.

Now, the locking system for the AUX mode operation has been released. Engaging the parking brake can reactivate the AUX mode, as long as the car's ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3), of “To activate your auxiliary devices.”

Each time the ignition is turned OFF, perform the procedure of “To activate your auxiliary devices.”

•If you try to activate the auxiliary device while driving, the display will show the warning-PICTURE OFF FOR YOUR SAFETY.

1Touch [SRC] on the main source screen. The source screen appears on the display.

2Touch [AUX]*.

The external input screen is displayed.

*AUX-1 to AUX-3 are displayed if the external input devices (maximal 3) are connected, or the name which is given as the source name in “Naming External Devices” on page 33 is displayed.

•If the AUX mode is not displayed on the main menu, set AUX IN to ON by following "Setting the AUX Mode" (page 33).

•The display mode changes by touching [WIDE].

For operation, refer to “Switching Display Modes” on page 24.

51-EN