Setting the VISUAL Button on the Unit

The unit’s VISUAL button function can be changed.

Setting item: CUSTOMISE KEY

Setting contents: AUDIO SETUP / SAT / TEL

AUDIO

SETUP: Pressing and holding VISUAL for at least 2 seconds will recall the AUDIO SETUP screen.

SAT: If you press and hold VISUAL for at least 2 seconds when either the XM or SIRIUS Receiver Box is connected, the Weather or Traffic channels will be recalled.

TEL: If you press and hold VISUAL for at least 2 seconds when the Bluetooth Box is connected, the Bluetooth TEL screen will be recalled.

Setting the Digital Output

To connect an audio processor using the optical digital output, set to “ON” by the following procedure.

Setting item: OPTICAL OUT

Setting contents: OFF / ON

Afterwards, set ACC to OFF once, then turn it ON again. The setting of Digital Output is decided.

Subwoofer On and Off

Setting item: SUBWOOFER

Setting contents: OFF / ON

OFF: Subwoofer output is off.

ON: Subwoofer output is on.

DISPLAY Setup

Display Setup Operation

To display the Display mode screen:

To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below.

1Bring your vehicle to a complete stop at a safe location. Engage the parking brake.

2Keep pushing the foot brake and release the parking brake once then engage it again.

3When the parking brake is engaged for the second time, release the foot brake.

For automatic transmission vehicles, place the transmission lever in the Park position.

Now, the locking system for the Display mode operation has been released. Engaging the parking brake can reactivate the Display mode, as long as the car’s ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3) of “To display the Display mode screen.”

Each time the ignition is turned OFF, perform the procedure of “To display the Display mode screen.”

The following steps 1 to 4 are common operations to each “Setting item” of DISPLAY Setup. Refer to each section for details.

1 Touch [SETUP] on the main source screen.

The SETUP selection screen is displayed.

2 Touch [DISPLAY].

The DISPLAY SETUP screen appears.

3 Touch [ ], [ ] or [ ] etc., of the desired item to change its setting.

Setting items:

VISUAL EQ / DIMMER / DIMMER LOW LEVEL / BACKGROUND / AUTO BACKGROUND / DATA DOWNLOAD / BASE COLOR / SCREEN ALIGNMENT

4 Touch [RETURN] to return to the previous screen.

Touch and hold [RETURN] for at least 2 seconds to return to the main source screen that was displayed before the setup operation was started.

Immediately after changing the settings of Display Mode (While the system is writing data automatically) do not turn the ignition key (engine key) to OFF. Otherwise, the settings may not be changed.

37-EN

Page 39
Image 39
Alpine IVA-W203 owner manual Display Setup Operation, Setting the Visual Button on the Unit, Setting the Digital Output