Altec Lansing IMT520 How to Disconnect the Rechargeable Battery, Pull out the battery holder

How to Disconnect the Rechargeable Battery

1Unplug the inMotion Kick from the wall outlet.

2Remove the rechargeable battery compartment cover at the back of the system by removing the screw.

3Unplug the battery and remove it.

WARNING There is a danger of explosion if the battery is incorrectly replaced. Replace it only with the same or equivalent type. Do not expose it to excessive heat such as sunshine, fire, etc.

BATTERY DISPOSAL The battery used in this product must be properly recycled or disposed of. Please contact your local recycling center for proper battery handling and disposal instructions.

Rated Voltage: 3.7V  Capacity: 1800mAh  Type: McR18650

Getting Started

How to Install the Full-featured Remote Battery

The full-featured remote battery (included) is not installed at the factory. To install the battery, follow the steps below:

1Pull out the battery holder.

The battery door is located on the lower end of the remote. Simply pull the tab to open the battery holder.

2Position the included lithium coin battery (CR2025) battery so it sits in the battery holder correctly.

Make sure the polarity (the + and – sides of the battery) is correct.

3Replace the battery door.

NOTE Please discard used batteries properly.

EN

5