Chapter 1. Installing an AMCC 3ware 9550SX RAID Controller
3Align the cable connector with the connector on the controller, matching the slotted key and carefully mate the connectors.
Note: The connectors on the end of the serial controller and the drive are susceptible to damage from excessive bending. Be careful not to insert or remove the SATA cable connector at an angle.
Figure 6. SATA Cables Being Inserted Into Port
4
5Repeat steps 2 and 3 for each additional SATA cable. (You will connect one cable for each hard drive you will attach.)
To install the controller in the computer
1If the computer is running, shut it down. Turn off power to the computer and disconnect the power cord from the outlet.
2Make sure you are properly grounded. (For details about safety precautions, see page 4.)
3Open the computer case according to the manufacturer’s instructions.
4Find the PCI or
For a discussion of which slot to use, see “Selecting the Slot in Which to Install the Controller” on page 2.
5Remove the metal filler bracket for the slot.
103ware 9550SX Serial ATA RAID Controller Quick Install Guide
