4. Check for voltage across TB#4 and TB#7. If voltage is evident, problem is defective burner hi-limit switch P/N: 130401 or the sail switch* P/N: 122200, or the harness connecting these two (2) devices to the terminal (block #4 and #2).
5. Check for voltage across TB#3 and TB#7. If voltage is evident, problem is defective basket hi-limit switch P/N: 130103 or the harness connecting this device to the terminal block #3 and #4.
6. Check for voltage across the computer's 15-pin connector, #4 (orange wire), and GND. Spade terminal on the computer. If voltage is evident, problem is the orange wire from the computer's 15- pin connector, #4 to the terminal block #3. There is a bad connection on either end or faulty computer.
* Make sure the sail switch damper is closing properly. If so, check to see if it is making contact with the switch. If the sail switch damper is not closing properly check for exhaust restriction, or exhaust damper restriction and/or clogged lint screen.
NOTE: For models with a 3-phase motor, check rotation direction of impellor (fan) as noted on label at rear of dryer.
42
