Cisco Systems OL-11497-03 manual Using Diagnostics, Obtain and Place the Diagnostics Image

Chapter 5 Field Diagnostics for the Cisco 12000 Series Router

Using Diagnostics

Field Diag eeprom values: run 8 fail mode 0 (PASS) slot 0 last test failed was 0, error code 0

Shutting down diags in slot 0

Board will reload Router#

Router#

Router#

SLOT 0:00:00:42: %SYS-5-RESTART: System restarted -- Cisco Internetwork Operating System Software

IOS (tm) GS Software (GLC1-LC-M), Experimental Version 12.0(20030909:221642) [hsiang-conn3 108]

Copyright (c) 1986-2003 by cisco Systems, Inc. Compiled Thu 11-Sep-03 15:19 by hsiang

Using Diagnostics

Before proceeding with any diagnostics procedures, review the following:

•Obtain and Place the Diagnostics Image, page 5-6

•Upgrade the FPGA Image on a Line Card, page 5-7

Obtain and Place the Diagnostics Image

Before you can use the line card field diagnostics commands, you must obtain and place a valid diagnostics image on a separate Flash memory card installed in the router or on a TFTP boot server.

Field diagnostics images are approximately 18 MB in size. Cisco IOS images are slightly larger. A single 64-MB Flash memory card can contain both images, or these images can be stored individually on two 20-MB memory cards inserted into in card slot 0 and slot 1 on the RP. To accommodate future feature releases, it is recommended that you use larger Flash memory disks.

The diagnostics image is named c12k-fdiagsbflc-mz.120-25.Sand is always available on Cisco.com. 120-25.S is the version number of the image that corresponds to the Cisco IOS image, in this example, Cisco IOS Release 12.0(25)S.

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
5-6	OL-11497-03