Cisco Systems OL-11497-03 manual Removing and Installing an Alarm Card

Chapter 6 Maintaining the Router

Removing and Installing a Clock and Scheduler Card, Switch Fabric Card, or Alarm Card

Removing and Installing an Alarm Card

The two alarm cards occupy the card slots in the alarm card bay. These slots are located on the bottom left side of the chassis, directly under the clock and scheduler card slots. (See Figure 6-31.) Figure 6-35shows a partially-ejected alarm card.

Figure 6-35 Removing and Installing an Alarm Card

AUX

CONSOLE

GIGABIT ROUTE PROCESSOR

CISCO 12000

GIGABIT SWITCH ROUTER

101408

1

2

1

Alarm card

2

Captive screw (2)

Note The alarm cards support OIR, so you can remove and install an alarm card while the system remains powered up.

Procedures for removing and installing an alarm card are described in the following sections:

•Removing an Alarm Card, page 6-66

•Installing an Alarm Card, page 6-66

•Verifying the Installation of the Alarm Card, page 6-67

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03		6-65