Cisco Systems OL-11497-03 manual Verifying the Installation of the Clock and Scheduler Card

Chapter 6 Maintaining the Router

Removing and Installing a Clock and Scheduler Card, Switch Fabric Card, or Alarm Card

Step 6 Use both thumbs to slide the card carrier into the CSC slot until the ejector levers make contact with the front of the card cage, then stop.

Step 7 Pivot the ejector levers toward the faceplate until the connector seats in the backplane.

Caution CSC ejector levers may not fit flush against the CSC faceplate. To ensure that the CSC is properly seated and ensure EMC compliance, tighten the captive screws. Do not overtighten the captive screws; you might strip the threads on the screw or in the insert in the CSC faceplate.

Step 8 Tighten the two captive screws.

Verifying the Installation of the Clock and Scheduler Card

To verify router operation after installing a replacement CSC, visually check the LEDs on the two alarm cards. (See Figure 6-33.) When the system is operating normally, the following LED conditions should be true.

LEDs that normally should be on:

•One MBUS status LED labeled ENABLED

•Two CSC status LEDs labeled ENABLED

•Three SFC status LEDs labeled ENABLED LEDs that normally should be off:

•One MBUS status LED labeled FAIL

•Two CSC status LEDs labeled FAIL

•Three SFC status LEDs labeled FAIL

•Three router alarm LEDs labeled CRITICAL, MAJOR, MINOR

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
6-60	OL-11497-03