Cisco Systems OL-11497-03 manual Verifying the Running Configuration Settings

Chapter 3 Installing the Router

Configuration Changes

BOOTFLASH: GS Software (GSR-BOOT-M), Version 11.2(18)GS4, EARLY

DEPLOYMENT RELE

Getty uptime is 22 hours, 15 minutes

System returned to ROM by reload

System image file is "tftp://xxx.xx.xx.xxx/directory/name/gsr-p-mz"

cisco 12406/GRP (R5000) processor (revision 0x05) with 262144K bytes of memory.

R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache Last reset from power-on

1 Route Processor Card

.

.

.

Configuration register is 0x0

.

.

.

router#

Verifying the Running Configuration Settings

To check the running configuration settings or any changes made to settings before you save them, enter the show running-configcommand at the privileged EXEC mode prompt. For a Quad OC-3c/STM-1c POS interface installed in slot 1, the show running-configcommand typically displays output in the form shown in the example below. Depending on the image version of the Cisco IOS software running on your router and the way it is equipped, the results of your show running-configcommand might be different.

show running Config Command Example

		router# show running-config
		Building configuration...
		Current configuration:
	!
		version 12.0
		no service pad
		no service udp-small-servers
		Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
3-62		OL-11497-03