Cisco Systems OL-11497-03 manual Wait, Optional Allows you to manipulate the download timeout

Chapter 5 Field Diagnostics for the Cisco 12000 Series Router

		Using the diag Command
Table 5-1	diag Command Reference (continued)
Command		Description
wait		(Optional) Stops the automatic reloading of the Cisco IOS
		software on the line card after the successful completion of
		the field diagnostic testing. If you use this keyword, you
		must use the microcode reload slot global configuration
		command, or manually remove and insert the line card (to
		power it up) in the slot so that the RP recognizes the line
		card and downloads the Cisco IOS software image to the
		line card.
coe		(Optional) Continue On Error. Normally the field
		diagnostics stop immediately upon failing any one test
		within a test session. Using the coe keyword forces the
		testing to continue to the end of the internal test list, even
		if a failure occurs. Caution should be exercised because in
		some cases where a cascade of failures is found, using this
		option MAY require the router to be reloaded, affecting all
		RPs and line cards. This option is only available for line
		cards and RPs.
full		(Optional) The default set of tests emphasize memory and
		data path tests. To force the line card or RP to complete the
		most extensive set of tests, use the full option. The test time
		will be slightly longer. This option is only available for line
		cards and RPs.
dl-timeout-plus		(Optional) Allows you to manipulate the download timeout
<1-2000 seconds>		value. 300 seconds is the baseline value. Any value from 1
		to 2000 adds that value to 300. For example, a
		dl-timeout-plusvalue of 12 makes the total value 312
		seconds. Supports users with slow TFTP boot paths.

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03		5-11