Cisco Systems OL-11497-03 manual GRP Console DCE and Auxiliary DTE Port Connections

Chapter 3 Installing the Router

Connecting to the Console and Auxiliary Ports

Figure 3-8 GRP Console DCE and Auxiliary DTE Port Connections

Modem

DB-25 female

	E
		J
		E
		C
		T
S
L S
O L
	T O
	-	T
	0	-
		1
AUX	R	E
	E
	S
		T

Auxiliary port

Console terminal DB-25 male

Console port

LIN
K	C
T	O

XL L

R

X

M		H10735
II
	R
	J
	-
	4
	5

GRP

Check your terminal documentation to determine the baud rate of the terminal you plan to use. If your documentation does not specify settings, use the following terminal settings: 9600 baud, 8 data bits, no parity, and 2 stop bits. You will need an EIA/TIA-232 DCE console cable to connect the terminal to the console port.

Note To comply with Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety, connect all console, auxiliary, and Ethernet interfaces only to intrabuilding or nonexposed wiring or cabling. The intrabuilding cable must be shielded and the shield must be grounded at both ends.

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03		3-15