Cisco Systems OL-11497-03 manual Ventilation

Models: OL-11497-03

1 344
Download 344 pages 57.99 Kb
Page 93
Image 93

Chapter 2 Preparing for Installation

Site Requirement Guidelines

in the rack. Ensure that cables from other equipment do not impair access to the card cages, requiring you to disconnect cables unnecessarily to perform equipment maintenance or upgrades.

Ventilation

The blower module is mounted at the rear of the chassis; air flow to the air filters and blower module should not be blocked.

Note Warm air is exhausted from the rear of the chassis. Maintain 6 inches (15.24 cm) of clearance at both the inlet and exhaust openings on the chassis to allow sufficient air flow.

When placing multiple Cisco 12006 and Cisco 12406 Routers in the same rack, ensure that there is sufficient ventilation to accommodate the routers.

Equipment located near the bottom of the rack can generate excessive heat that is drawn upward and into the intake ports of equipment above, possibly leading to overheating.

The heated exhaust air from other equipment can enter the inlet air vents and cause overheating inside the router.

A ventilation system that is too powerful in an enclosed rack can also prevent cooling by creating negative air pressure around the chassis and redirecting the air away from the air intake vent. If necessary, operate the router with the rack door open or in an open rack.

The correct use of baffles inside an enclosed rack can assist in cooling the router.

 

 

Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide

 

 

 

 

 

 

OL-11497-03

 

 

2-13

 

 

 

Page 93
Image 93
Cisco Systems OL-11497-03 manual Ventilation