Figure 3-24. Removing and Installing the Power Distribution Board
4
3
2
1 
1 | retention tabs (3) | 2 | retention slots (3) | 3 | power distribution board |
4 screws (7)
Installing the Power Distribution Board
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.
1Position the three retention slots on the power distribution board with the three retention tabs on the bottom of the chassis. See Figure
2Secure the power distribution board with the seven screws.
3Install the system board. See step 3 through step 14 in "Installing the System Board."
4Install the power supplies. See "Replacing a Power Supply" on page 52.
5Close the system. See "Closing the System" on page 47.
6Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Installing System Components
85
