Dell EMU01 owner manual Retention slots Installing System Components

9Remove the SAS backplane:

a Pull the spring-loaded blue retention pin away from the front of the backplane, then slide the backplane upward. See Figure 3-26.

b When the backplane cannot slide upward any farther, pull the backplane toward the back of the system to remove it from the retention hooks.

c Lift the board out of the system, being careful to avoid damaging components on the face of the board.

d Place the SAS backplane face down on a work surface.

Figure 3-26. Removing and Installing the SAS Backplane

23

4

1

5

1	retention pin	2	SAS backplane	3	control-panel cable connector
4	installation alignment slot	5	retention slots (7)

88

Installing System Components