Dell EMU01 E1414 CPU # Thermtrip, E1418 CPU # Presence, E1423, Missing, E141C CPU Mismatch

Table 1-7. LCD Status Messages (continued)

Line 1	Line 2	Causes	Corrective Actions
Message	Message
E1414	CPU # Thermtrip	Specified microprocessor is out of	See "Troubleshooting System
		acceptable temperature range and	Cooling Problems" on page 105.
		has halted operation.	If the problem persists, ensure
			that the microprocessor heat
			sinks are properly installed. See
			"Troubleshooting the
			Microprocessors" on page 114.
			NOTE: The LCD continues to
			display this message until the
			system’s power cord is
			disconnected and reconnected to
			the AC power source, or the SEL is
			cleared using either Server
			Assistant or the BMC Management
			Utility. See the Dell OpenManage
			Baseboard Management
			Controller User’s Guide for
			information about these utilities.
E1418	CPU # Presence	Specified processor is missing or	See "Troubleshooting the
		bad, and the system is in an	Microprocessors" on page 114.
		unsupported configuration.
E1423	CPU # VRM	VRM for specified processor is	Remove and reseat the specified
	Missing	missing or faulty.	VRM. See "Processor VRMs" on
			page 66.
			If the problem persists, the
			system board is faulty. See
			"Getting Help" on page 129.
E141C	CPU Mismatch	Processors are in a configuration	Ensure that your processors
		unsupported by Dell.	match and conform to the type
			described in the Microprocessor
			Technical Specifications outlined
			in your system’s Getting Started
			Guide.
E141F	CPU Protocol	The system BIOS has reported a	See "Getting Help" on page 129.
		processor protocol error.
E1420	CPU Bus PERR	The system BIOS has reported a	See "Getting Help" on page 129.
		processor bus parity error.
E1421	CPU Init	The system BIOS has reported a	See "Getting Help" on page 129.
		processor initialization error.

About Your System

19