Table 1-8. System Messages (continued)

Message

Causes

Corrective Actions

 

 

 

Attempting to update

Remote Configuration request has

Wait until the process is complete.

Remote Configuration.

been detected and is being processed.

 

Please wait...

 

 

 

 

 

BIOS Update Attempt

Remote BIOS update attempt failed.

Retry the BIOS update. If problem

Failed!

 

persists, see "Getting Help" on page 129.

 

 

 

Caution! NVRAM_CLR jumper

NVRAM_CLR jumper is installed.

Remove the NVRAM_CLR jumper. See

is installed on system

CMOS has been cleared.

Figure 6-1 for jumper locations.

board.

 

 

 

 

 

Diskette drive n seek

Incorrect configuration settings in the

Run the System Setup program to

failure

System Setup program.

correct the settings. See "Using the

 

 

System Setup Program" on page 31.

 

Faulty or improperly installed diskette

Replace the diskette. If the problem

 

drive.

persists, see "Troubleshooting a Diskette

 

 

Drive" on page 108.

 

Loose diskette drive interface cable, or

Reseat diskette drive interface cable, or

 

loose power cable.

power cable. See "Troubleshooting a

 

 

Diskette Drive" on page 108.

 

 

 

Diskette read failure

Faulty or improperly inserted diskette.

Replace the diskette. If the problem

 

 

persists, see "Troubleshooting a Diskette

 

 

Drive" on page 108.

 

 

 

Diskette subsystem reset

Faulty or improperly installed

Replace the diskette. If the problem

failed

diskette.

persists, see "Troubleshooting a Diskette

 

 

Drive" on page 108.

Drive not ready

Diskette missing from or improperly

 

inserted in diskette drive.

Replace the diskette. If the problem persists, see "Troubleshooting a Diskette Drive" on page 108.

Error: Memory failure detected. Memory size reduced. Replace the faulty DIMM as soon as possible.

Faulty or improperly seated memory

See "Troubleshooting System Memory"

module(s).

on page 106.

Remote

configuration

System unable to process Remote

Retry Remote Configuration.

update

attempt failed

Configuration request.

 

Fatal error caused a

Fatal system error.

system reset: Please check

 

the system event log for

 

details.

 

Check the system event log for the specific cause, then see the appropriate section in"Troubleshooting Your System" on page 97.

About Your System

25

Page 25
Image 25
Dell EMU01 Attempting to update, Remote Configuration, Please wait Bios Update Attempt, Failed, Is installed on system