Dell EMU01 owner manual System Memory, Connector

Figure 3-9. RAC Card Connectors

2

1

3

1 RJ-45 connector	2	44-pin MII cable connector	3	50-pin management cable
				connector

9Reinstall the storage controller card.

10Reinstall the cooling shrouds. See "Replacing the Cooling Shrouds" on page 50.

11Reconnect all cables to the storage controller card and feed the cables through the appropriate channels and keepers on the cooling shrouds.

12Close the system. See "Closing the System" on page 47.

13Reconnect the system and peripherals to their power sources, and turn them on.

14Enter the System Setup program and verify that the setting for the Boot Sequence has changed to reflect the presence of the RAC card. See "Using the System Setup Program" in your Hardware Owner’s Manual.

15Exit the System Setup program and reboot the system.

When the system boots, the Remote Access Control Detected message displays and the option ROM and firmware information for the RAC displays.

Press <Ctrl><e> to enter the RAC configuration screen. See the RAC documentation for information on configuring and using the RAC.

System Memory

You can upgrade your system memory to a maximum of 32 GB (two-processor configurations) or 64 GB (four-processor configurations) by installing 667-MHz registered DDR-II memory modules (DIMMs) in sets of 512-MB, 1-GB, 2-GB, or 4-GB modules. The sixteen memory sockets are located on the system board under the cooling shrouds. Each processor has four memory channels, organized in sets of two.

Installing System Components

57