Cisco Systems OL-11497-03 manual Power a, DC-Input Power Entry Module

Chapter 1 Product Overview

Power Subsystems

power should be connected to the terminal block. A negative lead is connected to the top port, a positive lead to the middle port, and a ground lead to the bottom port. (See Figure 1-15.)

Figure 1-15 Cisco 12006 Router DC PDU Power Connector Block

POWER A

4

+ GND

1

2

3

			57993
1	Negative Terminal Port	3	Ground Terminal Port
2	Positive Terminal Port	4	Terminal Port Connector Screws

DC-Input Power Entry Module

The DC-input PEM is a removable power module that installs in one of the bottom two bays on the front of the chassis (see Figure 1-1). These power modules support the OIR feature and are hot-swappable.

Note When operating your router on a single power module, the second power module bay must have a blank filler (MAS-GSR-PWRBLANK=) installed to ensure EMI compliance.

Caution Cisco 12006 and Cisco 12406 routers are configured for either AC power or DC power. Do not mix AC-input power supplies and DC-input PEMs.

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
1-44	OL-11497-03