Cisco Systems OL-11497-03 Tools and Equipment, Removing and Installing a Clock and Scheduler Card

Models: OL-11497-03

1 344
Download 344 pages 57.99 Kb
Page 301
Image 301

Chapter 6 Maintaining the Router

Removing and Installing a Clock and Scheduler Card, Switch Fabric Card, or Alarm Card

Tools and Equipment

You need the following items to remove and replace a CSC, an SFC, or an alarm card:

ESD-preventive strap

3/16-inch flat-blade screwdriver

Antistatic bag or similar ESD-preventive container

Removing and Installing a Clock and Scheduler Card

A Cisco 12006 or Cisco 12406 Router configured for redundant CSCs will have two CSCs installed in the two CSC slots; a router configured for nonredundant operation will have one CSC installed in one of the CSC slots, and will have a CSC blank filler installed in the second CSC slot. (See Figure 6-31.) Figure 6-32shows a partially ejected CSC.

Note The CSCs support OIR, so when the router is equipped with two CSCs, you can remove either CSC while the system remains powered up. In a router equipped with only one CSC, you must shut down the router before removing the CSC.

Caution When removing CSCs or CSC blank fillers, remove each component entirely from the chassis and place it in an ESD-safe environment. Do not allow the card or blank to rest partially inserted into the slot, as this will damage the electromagnetic interference (EMI) shielding on the card in the slot directly below.

Caution Two CSCs (redundant configuration) are required to support CSC online insertion and removal (OIR). This allows you to remove and replace a CSC or an SFC while the system remains powered on. If only one CSC is present, do not remove any cards while the system is powered on.

Procedures for removing and installing a CSC are described in these sections:

Removing a Clock and Scheduler Card, page 6-58

Installing a Clock and Scheduler Card, page 6-59

 

 

Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide

 

 

 

 

 

 

OL-11497-03

 

 

6-57

 

 

 

Page 301
Image 301
Cisco Systems OL-11497-03 manual Tools and Equipment, Removing and Installing a Clock and Scheduler Card