Cisco Systems OL-11497-03 manual Setup Command Interactive Script Example

Chapter 3 Installing the Router

Configuration Changes

The output shown in this example depends on the image version of the Cisco IOS software and the way your router is equipped. Your configuration dialog might be different.

The setup command script is a self-guiding interactive script that prompts you for responses and provides default or alternative values wherever possible.

setup Command Interactive Script Example

Cisco Internetwork Operating System Software

.

.

.

--- System Configuration Dialog ---

Continue with configuration dialog? [yes/no]: Yes

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Basic setup only configures enough connectivity

for management of the system, extended setup will ask you to configure each interface of the system.

Would you like to enter basic management setup? [yes/no]: Yes

Configuring global parameters:

Enter host name [Router]: Router

The enable secret is a password used to protect access to privileged EXEC and configuration modes. This password, after entered, becomes encrypted in the configuration.

Enter enable secret [<Use current secret>]: alpha

The enable password is used when you do not specify an

enable secret password, with some older software versions, and some boot images.

Enter enable password: bravo

The virtual terminal password is used to protect access to the router over a network interface. Enter virtual terminal password: charlie Configure SNMP Network Management? [no]:

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
3-54	OL-11497-03