Cisco Systems OL-11497-03 Upgrading the RP and Line Card Memory, Reconnecting Power to the Router

Chapter 6 Maintaining the Router

Upgrading the RP and Line Card Memory

Reconnecting Line Card Network Interface Cables

Reconnect line card network interface cables as described in the “Connecting RP and Line Card Cables” section on page 3-11.

Reconnecting Power to the Router

For AC-powered systems, connect the facility AC power cables to the AC PDU as instructed in the “Connecting to an AC Power Source” section on page 3-29.

For DC-powered systems, connect the facility DC power cables to the DC PDU as instructed in the “Connecting to a DC Power Source” section on page 3-32.

Installing the Blower Module

Install the blower module on the replacement chassis as instructed in “Removing and Replacing the Blower Module” section on page 6-9.

Restarting the Router

Restart the router and verify that it has restarted successfully after replacing the chassis as instructed in the “Power On the Router” section on page 3-35.

Upgrading the RP and Line Card Memory

To upgrade the RP and line card memory, refer to the Cisco 12000 Series Router Memory Replacement Instructions publication (Document Number 78-4338-xx). It is available on-line at http://www.cisco.com and on the Cisco CD-ROM.

This publication contains the latest information about memory requirements and replacing memory on the Cisco 12000 Series Router RP and line cards. Consult this publication before replacing memory on your RP or line card, or adding memory to your RP or line card.

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03		6-77