Cisco Systems OL-11497-03 manual Removing the Chassis from the Equipment Rack

Chapter 6 Maintaining the Router

Removing and Installing the Chassis

Detaching the Supplemental Bonding and Grounding Connection

Detach the supplemental bonding and grounding cables from the defective chassis as explained in the “Supplemental Bonding and Grounding Connections” section on page 3-9.

Removing the Chassis

This section contains the following procedures:

•Removing the Chassis from a Tabletop or Flat Surface, page 6-74

•Removing the Chassis from the Equipment Rack, page 6-74

Removing the Chassis from a Tabletop or Flat Surface

Because of the weight and awkwardness of lifting and supporting the chassis, you will need two persons to remove the chassis from a tabletop or other flat surface safely. Each person should review and observe the safe lifting guidelines in the “Lifting Guidelines” section on page 2-5before attempting to remove the chassis.

To remove the defective chassis from a tabletop or flat surface, follow these steps:

Step 1 Ensure that all cables are disconnected and moved out of the way.

Step 2 With one person positioned on each side of the chassis to lift the weight of the chassis and hold it steady, move the chassis off of the tabletop or flat surface and carry it to the place prepared to store the defective chassis temporarily after it is removed.

Step 3 Set the chassis safely aside.

Removing the Chassis from the Equipment Rack

Before you remove the defective chassis from the equipment rack, examine how the chassis is mounted in the rack:

•Mounted directly against the rack flanges, but sitting on the optional rack-mounting brackets (see Figure 3-1 on page 3-4)

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
6-74	OL-11497-03