Cisco Systems OL-11497-03 manual Configuration register is 0x141 will be 0x102 at next reload

Chapter 4 Troubleshooting the Installation

Performing Other Configuration Tasks

This command sequence saves the new contents of the software configuration register to NVRAM, but these new settings do not take effect until you reload or reboot the router.

Step 5 Enter the show version privileged EXEC command to display the software configuration register value currently in effect. This value will be used the next time the router reloads. The value is displayed on the last line of the screen display, as in the following example:

Router# show version

.

.

.

Configuration register is 0x141 (will be 0x102 at next reload)

Step 6 Save the software configuration register settings as described in the “Problem Solving with Subsystems” section on page 4-14.

Note Configuration register changes take effect only after the system reloads, such as when you enter a reload command from the console.

Step 7 Reboot the router.

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03		4-7