Cisco Systems OL-11497-03 manual Removing a Clock and Scheduler Card, Csc

Chapter 6 Maintaining the Router

Removing and Installing a Clock and Scheduler Card, Switch Fabric Card, or Alarm Card

Figure 6-32 Removing and Installing a Clock and Scheduler Card

AUX

CONSOLE

GIGABIT ROUTE PROCESSOR

CISCO 12000

GIGABIT SWITCH ROUTER

101409

CISCO
12000	SERIES
GIGABIT
SWITCH
ROUTER

1

2

3

1

2

CSC 3 Ejector lever (2)

Captive screw (2)

Removing a Clock and Scheduler Card

To remove a clock and scheduler card, see Figure 6-32and follow these steps:

	Step 1	Attach an ESD-preventive strap to your wrist and connect the leash to the chassis
		or to another grounded, bare metal surface.
	Step 2	Loosen the two captive screws on each side of the CSC.
	Step 3	Grasp the card ejector levers and pivot them away from the CSC faceplate.
	Step 4	Slide the CSC halfway out of the slot, then stop.
	Step 5	Touching only the metal card carrier, use your free hand to support the bottom of
		the CSC.
	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
6-58		OL-11497-03