Cisco Systems OL-11497-03 - page 201

4-13
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
Chapter 4 Troubleshooting the Installation
Performing Other Configuration Tasks
Step 8 Enter no in response to the system configuration dialog prompts until the
following instruction is displayed:
Press RETURN to get started!
Step 9 Press Return.
After some interface configuration information is displayed, the user EXEC mode
prompt appears:
router>
Step 10 Enter the enable command at the user EXEC mode prompt to enter privileged
EXEC mode:
router> enable
Password: <password>
Router#
The prompt changes from router> to router# (> to #) indicates the change in
command mode.
Step 11 Enter the show startup-config command at the privileged EXEC mode prompt to
display the enable password in the configuration file.
router# show startup-config
.
.
.
Step 12 Enter the configure terminal command at the privileged EXEC mode prompt to
enter global configuration mode:
router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
router(config)#
Step 13 Change the software configuration register value back to its original value (noted
in Step 3). Alternatively, change this value to 0x0102 (the factory default) by
using the config-register 0xvalue command:
router(config)# config-register 0xvalue
router(config)#
Valu e is a hexadecimal number preceded by 0x, as in the following example:
router(config)# config-register 0x0102