Cisco Systems OL-11497-03 manual Maintaining the Router

C H A P T E R 6

Maintaining the Router

The Cisco 12006 or Cisco 12406 Router is equipped as ordered and is ready to install and start up when it leaves the factory. After you install and configure the router, you might need to perform other procedures to ensure that the router continues to operate properly. Also, as your networking requirements change, you might need to upgrade your system by adding or changing components.

This chapter describes how to maintain your router. The first section explains when and how to power down the router. The remaining sections describe the following maintenance procedures:

•Powering Down the Router, page 6-2

•Removing and Installing the Front Door on Cisco 12006 and Cisco 12406 Enhanced Series Router, page 6-3

•Cleaning or Replacing the Air Filters, page 6-7

•Cleaning or Replacing the Air Filters, page 6-7

•Removing and Replacing the Blower Module, page 6-9

•Removing and Replacing AC and DC Power Subsystem Components, page 6-13

•Removing and Replacing an AC PEM, page 6-18

•Removing and Replacing an AC PDU, page 6-24

•Removing and Replacing a DC PEM, page 6-31

•Removing and Replacing a DC PDU, page 6-37

•Removing and Installing an RP or a Line Card, page 6-47

•Removing and Installing an RP or a Line Card, page 6-47

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03		6-1