Cisco Systems OL-11497-03 manual Installing the Blower Module

Chapter 6 Maintaining the Router

Removing and Replacing an AC PDU

Step 9 Install the blower module (Figure 6-14):

a.Position the alignment holes on the blower module with the guide pins on the chassis and PDU.

b.Slide the blower over the guide pins toward the chassis until it mates with the PDU connector.

Caution To prevent damage to the connectors, do not use excessive force when installing the blower module.

c.Tighten the (4) captive screws to secure the blower module to the chassis.

d.Lower the carrying handle to its operating position.

Figure 6-14 Installing the Blower Module

101115

Step 10 Reconnect the power cords to the PDU and secure them using their retention clips. Step 11 Plug the power cords into their AC outlets.

Step 12 Power on the circuit breakers assigned to the AC outlets.

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03		6-29