Cisco Systems OL-11497-03 manual Reconnecting Cables to a Line Card

Chapter 6 Maintaining the Router

Removing and Installing an RP or a Line Card

Reconnecting Cables to a Line Card

When you replace an existing line card in the line card and RP card cage, you must reattach the line card cable-management bracket to the line card faceplate and reconnect the network interface cables to the replacement line card as described below.

If you have added a new line card, you must connect the additional network interface cables to the line card and route the cables across the front of the chassis to the vertical chassis cable-management bracket using the line card cable-management bracket as described below and shown in Figure 6-30, which shows a generic cable management bracket and velcro strap assembly.

Figure 6-30 Line Card Cable-Management Brackets with Velcro Straps

					Line card
					cable management
CARRIERRX					bracket
ACTIVE	CELL	CARRIERRX
	0
		ACTIVE	CELL	CARRIERRX
			0
				ACTIVE	CARRIERRX
				0
					ACTIVE CELL

OC-12/STM-4

Network interface cables

CARRIERRX
ACTIVE	CELL	CARRIERRX
	0
		ACTIVE	CELL	CARRIERRX
			0
				ACTIVE	CARRIERRX
				0
					ACTIVE	CELL

Velcro

strap

57803

OC-12/STM-4

To reconnect network interface cables to a line card, follow these steps:

Step 1 Attach an ESD-preventive strap to your wrist and connect the leash to the chassis or to another grounded, bare metal surface.

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
6-54	OL-11497-03