Keyboard Installation and Operation
Appendix A: ADCC0200/ADCC0300 VCR Reprogramming
The ability to reprogram the RS232 commands, that are sent out when the unit is in RS485 mode with Direct Control enabled, has been added. The default commands are those applicable to the Direct Control and are shown in the second and third columns below:
Label | Key | Default Command |
|
|
|
PLA | Play | <STX>FPL<ETX> |
REV | Reverse | <STX>RPL<ETX> |
|
|
|
PAU | Pause | <STX>PAU<ETX> |
REW | Rewind | <STX>REW<ETX> |
FWD | Fast Forward | <STX>FWD<ETX> |
REC | Record | <STX>REC<ETX> |
STP | Stop | <STX>STO<ETX> |
DZM | Digital Zoom | <STX>SEA<ETX> |
MEN | Menu | <STX>MEN<ETX> |
INC | Increment | <STX>ISP<ETX> |
DEC | Decrement | <STX>DSP<ETX> |
ENT | Enter | <STX>ENT<ETX> |
JLT | Joystick Left | <STX>ARL<ETX> |
JRT | Joystick Right | <STX>ARR<ETX> |
JUP | Joystick Up | <STX>ARU<ETX> |
JDN | Joystick Down | <STX>ARD<ETX> |
SLO | - | 0x64 |
FST | - | 0x14 |
PAR | Parity Change | 8N1 |
In order to reprogram these commands, the SEARCH (
) key must be pressed within 5 seconds of entering the
Special Config menu (achieved by simultaneously pressing the SHIFT 
and CLEAR 
keys) following a reset. Note that they may only be reprogrammed if the keyboard is configured for RS485 mode with Direct Control enabled.
Once the above key sequence has been pressed, the reprogramming takes place using a terminal or emulator attached to the RS232 port of the keyboard (as shown below). The baud rate will be whatever was configured on the keyboard for RS232 mode (see Setting the Baud Rate on page 34).
37
