ADCC0200 and ADCC0300
Running Tours
A tour is a dynamic sequence of camera views, each of which appears on a selected monitor screen for a specified dwell time, and each of which can have a
To run a tour:
1.Select a monitor.
2.Enter the tour identification number using the numeric keys. The number entered will appear on the right hand side of the top line of the LCD display.
3.Press the SEQUENCE (
) key.
4.The LCD display will show "Sequence = n" for approximately 5 seconds (where n is the tour identification number entered in step 2 above). Whilst the tour is running, the monitor will show the cameras and views comprising the tour e.g. C0023, C0012, C0003, C0023, V001, V124.
Note: when running a tour, information about the current camera is shown on the monitor displaying the tour. Tour information is not shown on the keyboard LCD display.
Holding a Tour
A tour can be stopped and held on a single camera entry. While a tour is on hold, all keyboard control actions (pan, tilt, lens adjustment, auxiliary on/off functions) can be performed on the held camera.
To hold a tour:
1.Hold down the SHIFT (
) key and press the SEQUENCE (
) key.
Restarting a Tour on Hold
To restart a held tour, press the SEQUENCE (
) key. The tour will continue running from the point at which it was previously held.
Stepping through a Tour
When a tour is held, the LAST (
) and NEXT (
) keys can be used to step through the tour.
To step through a tour:
1.To step forward press the NEXT (
) key.
2.To step backward, press the LAST (
) key.
22
