American Dynamics ADCC0300, ADCC0200 manual Appendix B Monitor Arming Commands

Keyboard Installation and Operation

Appendix B: Monitor Arming Commands

Monitors are armed for alarm call up with codes that specify the following three parameters:

1.The display method (single, dual, or block monitors).

2.The queuing method (sequence or hold).

3.The clearance method (instant, auto, or manual).

To arm a monitor with an ADCC0300 keyboard:

1.Call the monitor to be armed.

2.Enter the monitor arming code number (see table).

3.Press the FUNCTION () key, press the F1 () key.

A keyboard operator can also program any monitor armed for instant or auto clearance, for clearance via manual override. Manual override is enabled or disabled after the arming code is programmed. If enabled, an "A" will appear after the three-letter acronym for the arming code that appears on the monitor status line.

When using the AD1024 matrix switcher/controller system, monitors can be armed through S3 system setup software with a PC interface, or through the AD1024 embedded software with an ADCC0300 keyboard. Following is a table of monitor arming codes and the commands that enable the codes.

Monitor Arming Code	Monitor Acronym	Command Sequence
Display Arming Status	see entries below	300, FUNCTION, F1
Single, Sequence, Instant	SSI	301, FUNCTION, F1
Single, Sequence, Auto	SSA	302, FUNCTION, F1
Single, Sequence, Manual	SSM	303, FUNCTION, F1
Single, Hold, Instant	SHI	304, FUNCTION, F1
Single, Hold, Auto	SHA	305, FUNCTION, F1
Single, Hold, Manual	SHM	306, FUNCTION, F1
Block, Sequence, Instant	BSI	307, FUNCTION, F1
Block, Sequence, Auto	BSA	308, FUNCTION, F1
Block, Sequence, Manual	BSM	309, FUNCTION, F1
Block, Hold, Instant	BHI	310, FUNCTION, F1
Block, Hold, Auto	BHA	311, FUNCTION, F1
Block, Hold, Manual	BHM	312, FUNCTION, F1
Dual, Hold, Instant	DHI/DSI*	313, FUNCTION, F1
Dual, Sequence, Instant
Dual, Hold, Auto	DHA/DSA*	314, FUNCTION, F1
Dual, Sequence, Auto
Dual, Hold, Manual	DHM/DSM*	315, FUNCTION, F1
Dual, Sequence, Manual
Disarm Monitor		316, FUNCTION, F1
Enable Monitor Override		317, FUNCTION, F1
Disable Monitor Override		318, FUNCTION, F1

*In dual display applications, the first three-letter acronym is displayed on the hold monitor. The second three-letter acronym is displayed on the sequence monitor.

39