Installation | American Power Conversion RT XLI/XLICH specification

Installation

Stack or rack-mount front panel

PowerView Interface Display RJ45 Connector (pass through to rear panel RJ45 connector)

Serial Port

PowerView Cable Connector

SmartSlot with Network

Management Card

Ethernet port 10/100 Base-T

Cold Start/EPO Reset

PowerView installation for stack or rack-mount configurations

Prior to attaching the PowerView to the UPS:

1.Loosen the two bracket screws on the back of the PowerView module.

a.Slide the bracket to the position that will accommodate the screw holes on the UPS.

b.Tighten the screws on the bracket.

2.Secure the PowerView to the UPS using the two thumb screws attached to the PowerView.

Connect the PowerView cable to the PowerView connector on the UPS.

Smart-UPS RT 15000/20000 VA 230 Vac Stack/Rack-Mount 6U User Manual

3

Image 7

American Power Conversion RT XLI/XLICH user manual Installation, Stack or rack-mount front panel

Contents

XLI/XLICH Page Contents Page About this UPS Unpack package contents Maximum Number of XLBPs Supported by the Smart-UPS XL SpecificationsEnvironmental Specifications Physical Specifications Stack or rack-mount front panel Installation Rack-mount configuration Stack configuration Install and connect battery modules Install units in rack Route ethernet cable and install bezels Optional accessories Accessories Install the wiring trays, refer to graphics below Xlbp Install input and output wiring trays in UPS rear panel Adhere to national and local electrical codes when wiring Wiring Specifications Input/Output Jumper Configurations Input wiring options Single phase input, single phase output, dual feed Single phase input, single phase output, single feed Three phase input, three phase output, dual feed Three phase input, single phase output, single feedThree phase input, three phase output, single feed Three phase input, single phase output, dual feed L3 L2 L1 OSJ Output wiring options Single phase output connection to battery pack PDU Operation PowerView Interface Display Main Menu Screen Navigating menu screens Navigating sub menu screens Menu Tree System Sub menu screens External Battery Pack Connect load to UPS Connect power to UPS and loadCommunication Ports Connector Emergency Power Off EPO Output Jumper Configurations table Troubleshooting Display MessagesPage Refer to Contact Information in this Option 2 Correct bypass input Replace battery modules Maintenance, Transport, and ServiceService Terms of warranty Two-Year Warranty Models Regulatory Agency Approvals and Radio Frequency Warnings Date of product declaration