Installation |
| |
Tower front panel |
| |
| Interface Display | |
PowerView | Ethernet Port 10/100 | |
RJ45 Connector (pass through | ||
| ||
to Rear Panel RJ45 Connector | SmartSlot with Network | |
| ||
Serial Port | Management Card | |
| ||
PowerView Cable Connector | Cold Start/EPO reset |
Install PowerView
Prior to attaching the PowerView to the UPS:
1.Loosen the two bracket screws on the back of the PowerView module.
a.Slide the bracket to the position that will accommodate the screw holes on the UPS.
b.Tighten the screws on the bracket.
2.Secure the PowerView to the UPS using the two thumb screws attached to the PowerView.
3 |
