Connect PowerView
Connect the PowerView cable to the PowerView connector on UPS.
Route ethernet cable and install top cover and bezels
There are three ways to access the ethernet port on this unit:
1.Rear panel access utilizing ethernet jumper cable on front panel
2.Front panel access routing ethernet cable under top cover
3.Front panel access routing ethernet cable through bezel notch
Rear panel access utilizing ethernet jumper cable on front panel
Locate the RJ45 connector and the ethernet port on the front panel of the UPS. Connect the ethernet jumper cable (included), to the RJ45 connector and the ethernet port.
Connect a network cable (not included), to the RJ45 connector on the rear panel of the UPS.
Ethernet Cable connected to Rear Panel
RJ45 Connector
RJ45
Connector
Ethernet Cable
Ethernet Port
Ethernet
Jumper
Cable
Internal Pass Through Ethernet Cable Connecting
Front and Rear Panel RJ45 Connectors
4 |
