American Water Heater 6510319 Lighting Instructions, G. Bottled Propane Models

OPERATING YOUR WATER HEATER

Lighting Instructions

Read and understand these directions thoroughly before attempting to light or re-light the pilot. Make sure the tank is completely filled with water before lighting the pilot. Check the data plate near the gas control valve/thermostat for the correct gas. Do not use this water heater with any gas other than the one listed on the data plate. If you have any questions or doubts, consult your gas supplier or gas utility company.

L.P.G. (Bottled Propane) Models

Liquefied petroleum gas is over 50% heavier than air and in the occurrence of a leak in the system, the gas will settle at floor level. Basements, crawl spaces, skirted areas under mobile homes (even when ventilated), closets and areas below ground level will serve as pockets for the accumulation of gas. Before lighting an L.P. gas water heater, smell all around the appliance at floor level. If you smell gas, follow the instructions as given in the warning on the front page.

When your L.P. tank runs out of fuel, turn off the gas at all gas appliances including pilot lights. After the tank is refilled, all appliances must be re-lit according to their manufacturer’s instructions.

Explosion Hazard

Replace viewport if glass is missing or damaged.

Failure to do so can result in death, explosion or fire.

LIGHTING INSTRUCTIONS

1.Remove the outer door.

2.Turn the temperature dial counterclockwise to its lowest setting.

120°F

BAR

130°F

RESET BAR BUTTON

GAS

CONTROL

KNOB

DIAL

STOP

INDEX

BARS

130°F

BAR

3. Turn gas control knob clockwise to the “OFF" position.

4. To clear any gas that may have accumulated, wait ten (10) minutes.

If you then smell gas, STOP! Refer to the safety warning on the cover. If you do not smell gas go to the next step.

5. Turn the gas control knob counterclockwise

to "PILOT.”

6.Depress the reset button all the way in and IMMEDIATELY depress the igniter button until you hear a loud click.

Observe the pilot through the view port. Do not release the reset button. Repeat immediately if pilot does not light on the first try. If the pilot does not light by the fourth attempt with the igniter, repeat steps 3 - 6. Continue to hold the button for about (1) minute after the pilot is lit. Release the reset button and it will pop back up. Pilot should remain lit. If the pilot light goes out, repeat steps 2 - 6.

IMPORTANT: If the pilot will not stay lit after several tries, turn gas control knob to "OFF" and call your service technician or gas supplier.

IMPORTANT: If the reset button does not pop up when released, stop and immediately shut off the gas at the line valve or tank. Call your service technician or gas supplier.

7. Turn the gas control knob

counterclockwise to "ON.”

8. Set the temperature dial to the desired setting.

9. Replace the outer door.

TO TURN OFF GAS TO APPLIANCE

1.Turn the temperature dial counterclockwise to its lowest setting.

2.Turn the gas control knob clockwise to the "OFF" position.

17