Power Cord Warnings !
If operating the portable DVD player from battery power, refer to Chapter 3 of this manual. Use an approved power cord.
If the original power cord is missing or lost, purchase a power cord:
-That is approved for use in your country.
-That is rated for the product and for the voltage and current marked on the product's electrical ratings label.
-That has a voltage and current rating greater than the voltage and current rating marked on the product.
-With a minimum wire diameter of 0.75 mm2/18AWG
-That is between 1 and 1.8 meters long.
If you have questions about the type of power cord to use, contact your authorized service provider.
Battery Warnings !
The portable DVD player comes with a
-Do not disassemble, crush, or puncture the battery pack.
-Do not short the battery pack's external contacts.
-Do not expose the battery pack to fire or water.
-Do not attempt to open or service the battery pack.
-Replace only with the battery pack designated for this product.
-Discard used batteries according to the manufacturer's instructions.
Copyright
This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
Manufactured under license from Dolby Laboratories.
"Dolby" and the
Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received; including interference that may cause undesired operation.
This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
2
