Loading Media when Peel and Present Option is Installed
1.Follow the same procedures in "Loading Media" up to closing of the Printhead Module.
2.Peel off 6 inches of labels from its backing.
3.Thread the label backing over the platen roller, over the Peel and Present Bar then back under the Peel and Present Bar towards the platen.
4.Turn on the power to “1” position.
5.With the Printhead module still open, press “FEED” button. The printer will advance the backing. Once the label backing comes out of the front of the printer, turn off the power to “O” position.
6.Pull down the printhead module down and latch it closed.
7.Close the top cover.
8.Turn on the power to “1” position.
9.Press the Feed key to feed up to the first label in the printer.
Note: The printer must be configured for Peel and Present Mode. This setting may be made in the windows driver, utility software, label design software or using printer commands from the host.
Label
Backing
Figure 12 - Loading Media - Peal and Present
User's Guide 18
