8.Pull out 6 inches of media and thread the end of the media between the Right and Left Media Guides.
9.Slide in the Right Media Guide until it is snug with the media.
Note: If the guides are positioned incorrectly, the media sensor may not sense the form properly.
If too loose the media may slide out from under them, uncover the paper out sensor and indicate a false paper out message.
If too tight so that the media may buckle and a paper jam could occur.
10.Thread the media over the roller until approximately 2 inches of the media shows out of the printer. (MAKE SURE THAT THE LABELS ARE FACING UP.)
11.Press the printhead module down firmly until it snaps into place.
12.Close the top cover.
13.Turn on the printer.
14.If you are using
Note: If the labels do not feed correctly, run the Label Sensor Calibration test (see the section on Label Sensor Calibration).
Note: The first time media is loaded, the label sensor must be calibrated. After this initial calibration, further calibration is not needed unless the media length, media changes or irregular feeding occurs. See Label Sensor Calibration for instructions on how to calibrate the Label sensor.
User's Guide 17
