AMT Datasouth 400 manual STXa

System Level Commands

Command	Description	Remarks
<STX>a	Enable page/job echo characters
<STX>cxxxx	Set continuous paper length and
	disable edge sensor
<STX>Dxxxxxxx	Memory dump**	xxxxxxx : memory address in
		HEX value
<STX>Exxxx	Set copy count for stored label
<STX>e	Enable edge sensor
<STX>F	Feed a page
<STX>fxxx	Back feed from top position
<STX>G	Print stored label
<STX>I	Download graphics	either PCX, BMP, PCX
		or HEX format
<STX>J	Set pause for each label
<STX>j	Cancel pause
<STX>KQ	System configuration details
<STX>L	Enter label formatting state
<STX>Mxxxx	Set maximum label length
<STX>m	Set measurement in metric
<STX>n	Set measurement in inches
<STX>Oxxxx	Set start of print position
<STX>P	Enable data dump
<STX>Q	Clear memory (fonts & graphics)
<STX>r	Select reflective sensor
<STX>Sn	Set feed rate for motor	n : ‘A’, ‘B’ or ‘C’
<STX>T	Print test pattern
<STX>Vn	Set Cutter or Peel and Present	n : ‘1’ - enable cutter,
	configuration	‘4’ - enable peel and
		Present
<STX>v	Printer version information
<STX>Wn	Graphics/fonts/labels and memory	n : ‘G’, ‘F’ or ‘L’.
	status details	RS-232 port only
<STX>x	Release file from printer memory

Note: **Models FM402DT and FM402TT, the memory dump command only needs a 6-digit hexadecimal.

User's Guide 28