User's Guide
Loading Paper 3-5
Loading Forms––continued
)Note: To load sheets wider than 16 inches, don't use the paper edge
guides. Just set a sheet into the paper entry slot behind the platen and let
it rest against the paper support. If necessary, you can remove the edge
guides.
,Caution: When loading a cut sheet, do not turn off or reset the printer
until the sheet is capture under the bail. If you do, a paper jam may
result during the next form feed.
You can load forms with pin-fed report paper already loaded, provided
that the pin-fed report paper is in the parked position. You'll learn more
about paper park later in this section.
Positioning a Form
If necessary, you can reposition a form after loading it. To do so, press
the Ready button to disable printing. Then, turn the Select-dial either
clockwise to advance the form or counterclockwise to reverse feed the
form. Then, press the Ready button again to enable printing.
Ejecting a Form
The printer ejects a form under any of the following conditions:
99
99
9When instructed by your software application.
99
99
9When printing reaches the last print line on the form.
99
99
9When printing reaches the number of lines you or your software
application specified for a form.
99
99
9When automatic form feeding is on and printing reaches a half-inch
from the bottom of the page.
99
99
9When you press the Form Feed button on the control panel.
User's Guide
Loading Paper 3-5
Loading Forms––continued
)Note: To load sheets wider than 16 inches, don't use the paper edge
guides. Just set a sheet into the paper entry slot behind the platen and let
it rest against the paper support. If necessary, you can remove the edge
guides.
,Caution: When loading a cut sheet, do not turn off or reset the printer
until the sheet is capture under the bail. If you do, a paper jam may
result during the next form feed.
You can load forms with pin-fed report paper already loaded, provided
that the pin-fed report paper is in the parked position. You'll learn more
about paper park later in this section.
Positioning a Form
If necessary, you can reposition a form after loading it. To do so, press
the Ready button to disable printing. Then, turn the Select-dial either
clockwise to advance the form or counterclockwise to reverse feed the
form. Then, press the Ready button again to enable printing.
Ejecting a Form
The printer ejects a form under any of the following conditions:
99
99
9When instructed by your software application.
99
99
9When printing reaches the last print line on the form.
99
99
9When printing reaches the number of lines you or your software
application specified for a form.
99
99
9When automatic form feeding is on and printing reaches a half-inch
from the bottom of the page.
99
99
9When you press the Form Feed button on the control panel.