AMT Datasouth AMTACCEL-5350 Using Page Setup Parameters, Using Page Setup Parameters

User's Guide

4-28 Control Panel

Using Page Setup Parameters

The next section of the Setup menu is page setup. Page setup param-

eters let you specify page size and margins.

LENG lets you specify the length of the form you are using in 1/6-inch

increments. This setting is very important since it controls continuous-

forms feeding.

You can select a number from 0 to 182. To determine the correct

number to use for your form, multiply the length of the form in inches by

6. For example, if your form is 11 inches long (11 inches × 6 = 66), you

should select 66. When you set form length, the printer sets the top-of-

form at the current line and clears the top and bottom margins.

If you set LENG to 0, the printer does not keep track of lines per page.

When using single sheets, a form feed control code ejects the page;

when using pin-feed paper, a form feed control code performs a carriage

return only.

WIDTH lets you specify the maximum print width. If the printer re-

ceives a line that exceeds the maximum print width, the excess prints on

the next line. You can specify 8, 13.6 or 16 inches. When you select

16, be sure to load paper so that it aligns with the blue line ( ) on the

paper scale.

)Note: When 16-inch wide printing is selected, printing is unidirectional

and slower than normal. Also, draft-quality printing is unavailable. If you

select draft-quality printing, the printer will use memo-quality.

26) LENG:66/6"

27) WIDTH:13.6

ABCDEFGH

ABCDEFGHIJKLMN

ABCDEFGHIJKLMNOPQ